4.5 I/O Signal Connections
4.5.4 I/O Circuits
4-47
4
Wiring and Connecting SERVOPACKs
Line-Driver Output Circuits
This section describes CN1 connector pins 33-34 (Phase-A Signal), 35-36 (Phase-B Signal),
19-20 (Phase-C Signal) and 48-49 (Phase-S Signal).
The serial data from the encoder is converted to two-phase (phases A and B) pulses. The
resulting output signals (PAO, /PAO and PBO, /PBO), origin pulse signal (PCO and /PCO), and
the absolute encoder position output signals (PSO and /PSO) are output with line-driver output
circuits. Connect the line-driver output circuits to line-receiver circuits at the host controller.
Example for Line-Receiver Circuit
Applicable line receiver:
SN75ALS175 or MC3486
manufactured by Texas Instruments
or the equivalent
Output line driver:
SN75ALS174 or
the equivalent
Host controller
SERVOPACK
220 Ω to
470 Ω
To Next Page
Loading...
