13.4 Utility Function (Fn) Operations on the Panel Operator
13.4.7 Reset Absolute Encoder (Fn008)
13-17
13
Panel Displays and Panel Operator Procedures
13.4.7
Reset Absolute Encoder (Fn008)
Refer to the following section for information on this utility function other than the procedure.
5.17 Resetting the Absolute Encoder on page 5-52
Step
Panel Display after
Operation
Keys Operation
1
Press the MODE/SET Key to enter Utility Function
Mode.
2 Press the UP Key or DOWN Key to display Fn008.
3
Press the DATA/SHIFT Key for approximately one
second. PGCL1 will be displayed.
4
Continue pressing the UP Key until PGCL5 is dis-
played.
Note: If you press the wrong key, no-oP will flash
on the display for approximately one second
and the display will return to the original Util-
ity Function Mode display. Repeat the opera-
tion from the beginning.
5
Press the MODE/SET Key.
The absolute encoder will be initialized.
When initialization has been completed, donE will
flash on the display for approximately one second.
6 –
After displaying donE, the display will return to the
PGCL5 display.
7
Press the DATA/SHIFT Key for approximately one
second to return the display to Fn008.
8 To enable the change to the settings, turn the power supply to the SERVOPACK OFF and ON again.
MODE
SET
DATA
To Next Page
Loading...
