YASKAWA SGD7S

13.4 Utility Function (Fn) Operations on the Panel Operator
13.4.24 Resetting Motor Type Alarms (Fn021)
13-29
13
Panel Displays and Panel Operator Procedures
13.4.24 Resetting Motor Type Alarms (Fn021)
Refer to the following section for information on this utility function other than the procedure.
12.2.7 Resetting Motor Type Alarms on page 12-45
13.4.25 Software Reset (Fn030)
Refer to the following section for information on this utility function other than the procedure.
6.14 Software Reset on page 6-95
13.4.26 Polarity Detection (Fn080)
Refer to the following section for information on this utility function other than the procedure.
5.11 Polarity Detection on page 5-28
Step
Panel Display after
Operation
Keys Operation
1
Press the MODE/SET Key to enter Utility Function
Mode.
2 Press the UP Key or DOWN Key to display Fn021.
3
Press the DATA/SHIFT Key for approximately one
second. The display shown at the left will appear.
4
Press the MODE/SET Key to reset the motor type
alarm. donE will flash on the display and the display
shown on the left will appear again.
5
Press the DATA/SHIFT Key for approximately one
second to return the display to Fn021.
6 To enable the change to the settings, turn the power supply to the SERVOPACK OFF and ON again.
MODE
/
SET DATA
/
MODE
/
SET DATA
/
MODE
/
SET DATA
/
MODE
/
SET DATA
/
MODE
/
SET DATA
/
Step
Panel Display after
Operation
Keys Operation
1
Press the MODE/SET Key to enter Utility Function
Mode.
2 Press the UP Key or DOWN Key to display Fn030.
3
Press the DATA/SHIFT Key for approximately one sec-
ond. The display shown at the left will appear.
4
Continue pressing the UP Key until the display shown
on the left appears.
Note: If you make a mistake during key operations, no_oP will
flash on the display for approximately one second.
5
Press the MODE/SET Key. The panel display will go
blank and then will change to the same initial status
display as when the power supply is turned ON.
MODE / SET DATA /
MODE / SET DATA /
MODE / SET DATA /
MODE / SET DATA /
MODE / SET DATA /
Step
Panel Display after
Operation
Keys Operation
1
Press the MODE/SET Key to enter Utility Function
Mode.
Continued on next page.
MODE / SET DATA /