7.3 Trial Operation for the Servomotor without a Load
7.3.3 Operating Procedure
7-9
7
Trial Operation and Actual Operation
4.
Check the jogging speed and then click the Servo ON Button.
The display in the Operation Area will change to Servo ON.
5.
Click the Forward Button or the Reverse Button.
Jogging will be performed only while you hold down the mouse button.
6.
After you finish jogging, turn the power supply to the SERVOPACK OFF and ON again.
This concludes the jogging procedure.
To change the speed, click the Edit Button and enter the new speed.
To Next Page
Loading...
