YASKAWA Z1000 CIMR-ZU*A Series User Manual

Terminal Board ................................................................. 179
Terminal Connections for Communication Self-Diagnostics. 263, 300, 330
Third Line Monitor Selection ................................................. 129
Through Mode ............................................................... 74, 86
Timer Function Input.............................................................76
Timer Function Off-Delay Time................................................36
Timer Function On-Delay Time ................................................36
Timer Output ......................................................................87
Time to Continue Making Fault Restarts .................................... 216
Torque Compensation Gain .....................................................53
Torque Compensation Primary Delay Time ..................................53
Torque Detection .................................................................86
Torque Detection 1 ...............................................................86
Torque Detection Level 1................................................ 115, 217
Torque Detection Selection 1 ........................................... 115, 217
Torque Detection Time 1 ................................................ 116, 217
Torque Reference/Torque Limit Selection from Comm. Option...........70
Transfer on Fault................................................................ 147
Transfer to Drive Operation ................................................... 144
U
U2, U3 Initialization............................................................ 134
U2, U3 Initial Value Selection ................................................ 223
Underload Detection .............................................................91
Undertorque Detection Operation ............................................ 114
Undervoltage Detection Level (Uv1) .................................. 103, 214
Unit Code ........................................................................ 131
Unit Selection for MEMOBUS/Modbus Register 0025H..... 252, 290, 309
Up/Down Frequency Reference Limit Selection .............................60
Up/Down Function ...............................................................75
User-Defined Parameter Upper/Lower ...................................... 130
User Monitor Selection after Power Up ..................................... 128
User Monitor Selection Mode................................................. 129
User Parameter Automatic Selection.....................................23, 186
User Parameter Default Value .......................................... 131, 222
User Parameters 1 to 32....................................................22, 186
User-Set Display Units Decimal Display.................................... 130
User-Set Display Units Maximum Value.................................... 129
User-Set Speed Agree 1..........................................................84
User-Set Speed Agree 2..........................................................87
V
V/f Gain During Speed Search..................................................34
V/f Pattern Defaults ............................................................ 240
V/f Pattern Selection .............................................................62
VERIFY.......................................................................... 132
Voltage Error Compensation Time Constant ............................... 126
Voltage Reduction Rate.................................................. 135, 224
Voltage Restoration Complete Level .................................. 136, 224
Voltage Restoration Level............................................... 135, 224
Voltage Restoration Sensitivity Time Constant ...................... 136, 224
Voltage Restoration Time Constant at Impact ........................ 136, 224
W
Waiting to Run ....................................................................90
Watt Hour Pulse Output .........................................................90
WRITE ........................................................................... 132
Writing BACnet Drive Parameters ........................................... 261
Writing to Multiple Registers ................................................. 315
Z
Zero Speed.........................................................................83
Index
YASKAWA SIEP YAIZ1U 03B YASKAWA AC Drive – Z1000 Programming Manual
337

YASKAWA Z1000 CIMR-ZU*A Series Specifications

General

Series	Z1000 CIMR-ZU*A Series
Category	Controller
Voltage Classes	200V, 400V
Enclosure	NEMA 1, NEMA 12
Frequency Range	0.01 to 400 Hz
Cooling Method	Fan Cooled
Operating Temperature	-10°C to 50°C
Application	HVAC
Control Method	V/f Control
Input Voltage	200-240V, 380-480V
Frequency Range (Input)	50/60 Hz
Power Rating	0.4kW to 630kW
Protection Features	Overcurrent, Overvoltage, Undervoltage
Communication Options	Modbus
Storage Temperature	-20°C to 60°C
Humidity	5% to 95% (non-condensing)
Enclosure Rating	IP20
Output Voltage	0-100% of input voltage