Yealink SIP-T48G

Configuring Basic Features
223
?p=features-general&q=load
Details of the Configuration Parameter:
Parameter
Permitted Values
Default
features.call_log_show_num
0 or 1
0
Description:
Enables or disables the IP phone to show the other party’s phone number instead of
the name in the call log lists.
0-Disabled
1-Enabled
If it is set to 0 (Disabled), the IP phone will show the other party’s name in the call log
lists.
If it is set to 1 (Enabled), the IP phone will show the other party’s phone number in
the call log lists.
Note: It works only if the value of the parameter “features.save_call_history” is set to
1 (Enabled).
Web User Interface:
Features->General Information->Call List Show Number
Phone User Interface:
None
To configure call list show number via web user interface:
1. Click on Features->General Information.
2. Select the desired value from the pull-down list of Call List Show Number.