Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series/CP860 IP Phones
64
server to IP phones. When the IP phone requests an IP address using the DHCP
protocol, the resulting response may contain option 66 or the custom option (if
configured) that contains the provisioning server address.
Static: You can manually configure the server address via phone user interface or
web user interface.
For more information on the above methods, refer to
Yealink_SIP-T2_Series_T19(P)
E2_T4_Series_CP860_IP_Phones_Auto_Provisioning_Guide
.
In order to get your IP phones running, you must perform basic network setup, such as IP
address and subnet mask configuration. This section describes how to configure basic
network parameters for IP phones.
Note
DHCP (Dynamic Host Configuration Protocol) is a network protocol used to dynamically
allocate network parameters to network hosts. The automatic allocation of network
parameters to hosts eases the administrative burden of maintaining an IP network. IP
phones comply with the DHCP specifications documented in RFC 2131. If using DHCP, IP
phones connected to the network become operational without having to be manually
assigned IP addresses and additional network parameters.
Procedure
DHCP can be configured using the configuration files or locally.
Configure DHCP on the IP phone.
Parameter:
network.internet_port.type
Configure DHCP on the IP phone.
Navigate to:
http://<phoneIPAddress>/servlet
?p=network&q=load
Configure DHCP on the IP phone.
This section mainly introduces IPv4 network parameters. IP phones also support IPv6. For
more information on IPv6, refer to IPv6 Support on page 647.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
