Yealink SIP-T48G - Configuring PC Port Mode

Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series/CP860 IP Phones
86
The PC port on the back of the IP phone is used to connect a PC. You can enable or
disable the PC (LAN) port on the IP phones via web user interface or using configuration
files. PC port is not applicable to CP860 IP phones.
Procedure
PC port mode can be configured using the configuration files or locally.
Configuration File
<y0000000000xx>.cfg
Configure the PC (LAN) port.
Parameter:
network.pc_port.enable
Local
Web User Interface
Configure the PC (LAN) port.
Navigate to:
http://<phoneIPAddress>/servlet
?p=network-pcport&q=load
Details of Configuration Parameters:
Parameters
Permitted Values
Default
network.pc_port.enable
0 or 1
1
Description:
Enables or disables the PC (LAN) port.
0-Disabled
1-Auto Negotiate
Note: It is not applicable to CP860 IP phones. If you change this parameter, the IP
phone will reboot to make the change take effect.
Web User Interface:
Network->PC Port->PC Port Active
Phone User Interface:
None
To enable the PC port via web user interface:
1. Click on Network->PC Port.