Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series/CP860 IP Phones
380
X ranges from 1 to 16 (for SIP-T48G/T46G/T29G)
X ranges from 1 to 12 (for SIP-T42G)
X ranges from 1 to 6 (for SIP-T41P/T27P)
X ranges from 1 to 3 (for SIP-T40P/T23P/T23G)
X ranges from 1 to 2 (for SIP-T21(P) E2)
X is equal to 1 (for SIP-T19(P) E2/CP860)
Web User Interface:
None
Phone User Interface:
None
To configure the presentation of the caller identity via web user interface:
1. Click on Account->Advanced.
2. Select the desired account from the pull-down list of Account.
3. Select the desired value from the pull-down list of the Caller ID Source.
4. Click Confirm to accept the change.
Connected Line Identification Presentation (COLP) allows IP phones to display the
identity of the connected party specified for outgoing calls. IP phones can display the
Dialed Digits, or the identity in a SIP header (Remote-Party-ID or P-Asserted-Identity)
received, or the identity in the From header carried in the UPDATE message sent by the
callee as described in RFC 4916. Connected line identification presentation is also
To Next Page
Loading...
