Getting Started
85
5-Full Duplex 1000Mbps (only applicable to SIP-T48G/T46G/T42G IP phones)
Note: It is not applicable to CP860 IP phones. For SIP-T29G and SIP-T23G IP phones,
you are not allowed to manually set the transmission speed to 1000Mbps. But you
can set it to auto negotiate to transmit in 1000Mbps. We recommend that you do not
change this parameter. If you change this parameter, the IP phone will reboot to
make the change take effect.
Web User Interface:
Network->Advanced->Port Link->PC Port Link
Phone User Interface:
None
To configure the transmission methods of Ethernet ports via web user interface:
1. Click on Network->Advanced.
2. Select the desired value from the pull-down list of WAN Port Link.
3. Select the desired value from the pull-down list of PC Port Link.
4. Click Confirm to accept the change.
A dialog box pops up to prompt that settings will take effect after a reboot.
5. Click OK to reboot the phone.
To Next Page
Loading...
