Yealink SIP-T48G - Page 104

Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series/CP860 IP Phones
84
network.pc_port.speed_duplex
Local
Web User Interface
Configure the transmission methods
of the Internet (WAN) port.
Navigate to:
http://<phoneIPAddress>/servlet?p=
network-adv&q=load
Details of Configuration Parameters:
Parameters
Permitted Values
Default
network.internet_port.speed_duplex
0, 1, 2, 3, 4 or 5
0
Description:
Configures the transmission method of the Internet (WAN) port.
0-Auto Negotiate
1-Full Duplex 10Mbps
2-Full Duplex 100Mbps
3-Half Duplex 10Mbps
4-Half Duplex 100Mbps
5-Full Duplex 1000Mbps (only applicable to SIP-T48G/T46G/T42G/CP860 IP phones)
Note: For SIP-T29G and SIP-T23G IP phones, you are not allowed to manually set the
transmission speed to 1000Mbps. But you can set it to auto negotiate to transmit in
1000Mbps. We recommend that you do not change this parameter. If you change
this parameter, the IP phone will reboot to make the change take effect.
Web User Interface:
Network->Advanced->Port Link->WAN Port Link
Phone User Interface:
None
network.pc_port.speed_duplex
0, 1, 2, 3 ,4 or 5
0
Description:
Configures the transmission method of the PC (LAN) port.
0-Auto Negotiate
1-Full Duplex 10Mbps
2-Full Duplex 100Mbps
3-Half Duplex 10Mbps
4-Half Duplex 100Mbps