Configuring Basic Features
259
?p=features-general&q=load
Details of Configuration Parameters:
features.direct_ip_call_enable
Description:
Enables or disables allow IP address call.
0-Disabled
1-Enabled
Note: If you want to receive an IP address call, make sure the value of the parameter
“sip.trust_ctrl” is set to 0 (Disabled).
Web User Interface:
Features->General Information->Allow IP Call
Phone User Interface:
None
To configure allow IP call feature via web user interface:
1. Click on Features->General Information.
2. Select the desired value from the pull-down list of Allow IP Call.
3. Click Confirm to accept the change.
To Next Page
Loading...
