Yealink SIP-T48G

Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series/CP860 IP Phones
334
Details of the Configuration Parameter:
Parameters
Permitted Values
Default
transfer.tran_others_after_conf_enable
0 or 1
0
Description:
Enables or disables the IP phone to transfer the local conference call to the other two
parties after the conference initiator drops the local conference call.
0-Disabled
1-Enabled
If it is set to 1 (Enabled), the other two parties remain connected when the
conference initiator drops the conference call.
Note: It works only if the value of parameters "account.X.conf_type" is set to 0 (Local
Conference).
Web User Interface:
Features->Transfer->Transfer on Conference Hang up
Phone User Interface:
None
To configure transfer on conference hang up via web user interface:
1. Click on Features->Transfer.
2. Select the desired value from the pull-down list of Transfer on Conference Hang up.
3. Click Confirm to accept the change.