Yealink SIP-T48G

Configuring Basic Features
337
Navigate to:
http://<phoneIPAddress>/servlet?p=
features-general&q=load
Details of Configuration Parameters:
Parameters
Permitted Values
Default
transfer.multi_call_trans_enable
0 or 1
1
Description:
Enables or disables the IP phone to select transfer-to party's call (a new call or
another existing call) during multiple calls when user presses the Tran/Transfer soft
key or TRAN/TRANSFER key.
0-Disabled
1-Enabled
If it is set to 1 (Enabled), the user can select to transfer the active call to a new call or
another existing call during multiple calls when the user presses the Tran/Transfer
soft key or TRAN/TRANSFER key.
If it is set to 0 (Disabled), the user can transfer the active call to a new call during
multiple calls when the user presses the Tran/Transfer soft key or TRAN/TRANSFER
key.
Note: It is not applicable to SIP-T48G/T46G/T29G IP phones.
Web User Interface:
Features->General Information->Allow Trans Exist Call
Phone User Interface:
None
To configure allow trans exist call via web user interface:
1. Click on Feature->General Information.