Yealink SIP-T48G

Getting Started
67
Parameters
Permitted Values
Default
Note: It works only if the value of the parameter “network.internet_port.type” is set to
0 (DHCP). If you change this parameter, the IP phone will reboot to make the change
take effect.
Web User Interface:
Network->Basic->IPv4 Config->Static DNS
Phone User Interface:
Menu->Settings->Advanced Settings (default password: admin)->Network->WAN
Port->IPv4->DHCP IPv4 Client->Static DNS
network.primary_dns
IPv4 Address
Blank
Description:
Configures the primary IPv4 DNS server.
Example:
network.primary_dns = 202.101.103.55
Note: It works only if the value of the parameter "network.static_dns_enable" is set to
1 (On). If you change this parameter, the IP phone will reboot to make the change
take effect.
Web User Interface:
Network->Basic->IPv4 Config->Static IP Address->Primary DNS
Phone User Interface:
Menu->Settings->Advanced Settings (default password: admin) ->Network->WAN
Port->IPv4->DHCP IPv4 Client->Static DNS (Enabled) ->IPv4 Pri.DNS
network.secondary_dns
IPv4 Address
Blank
Description:
Configures the secondary IPv4 DNS server.
Example:
network.secondary_dns = 202.101.103.54
Note: It works only if the value of the parameter "network.static_dns_enable" is set to
1 (On). If you change this parameter, the IP phone will reboot to make the change
take effect.
Web User Interface:
Network->Basic->IPv4 Config->Static IP Address->Secondary DNS
Phone User Interface:
Menu->Settings->Advanced Settings (default password: admin) ->Network->WAN