Yealink SIP-T48G

Getting Started
75
Details of Configuration Parameters:
Parameters
Permitted Values
Default
network.internet_port.type
0, 1 or 2
0
Description:
Configures the Internet (WAN) port type for IPv4.
0-DHCP
1-PPPoE (not applicable to SIP-T42G/T41P/CP860 IP phones)
2-Static IP Address
Note: It works only if the value of the parameter “network.ip_address_mode” is set to
0 (IPv4) or 2 (IPv4 & IPv6). If you change this parameter, the IP phone will reboot to
make the change take effect.
Web User Interface:
Network->Basic->IPv4 Config
Phone User Interface:
Menu->Settings->Advanced Settings (default password: admin) ->Network->WAN
Port->IPv4
network.ip_address_mode
0, 1 or 2
0
Description:
Configures the IP address mode.
0-IPv4
1-IPv6
2-IPv4 & IPv6
Note: If you change this parameter, the IP phone will reboot to make the change take
effect.
Web User Interface:
Network->Basic->Internet Port-> Mode(IPv4/IPv6)
Phone User Interface:
Menu->Settings->Advanced Settings (default password: admin) ->Network->WAN
Port->IP Mode
network.internet_port.ip
IPv4 Address
Blank
Description:
Configures the IPv4 address.
Example:
network.internet_port.ip = 192.168.1.20