CHAPTER 4 USB HID KEYBOARD
FEATURES (DONGLE)
Introduction
This chapter describes each USB HID keyboard feature and provides the programming bar codes for selecting
these features for the scanner.
The scanner ships with the settings shown in the USB HID Keyboard Default Table on page 4-2 (also see
Appendix A, Standard Default Parameters for all host device and miscellaneous scanner defaults). If the
default values suit the requirements, programming is not necessary. To change these values, scan a single bar
code or a short bar code sequence. The new settings are stored in non-volatile memory and are preserved
when the scanner powers down.
To return all features to their default values, scan the Reset Factory Defaults bar code on page 3-5. Throughout
the programming bar code menus, default values are indicated with asterisks (
*).
Scanning Sequence Examples
In most cases, scan only one bar code to set a parameter value. For example, to enable keypad emulation,
scan the Enable bar code under Emulate Keypad on page 4-8. The scanner issues a fast warble beep and the
LED turns green, indicating a successful parameter entry.
Other parameters require scanning several bar codes. See the parameter description for this procedure.
Errors While Scanning
Unless otherwise specified, if an error is made during a scanning sequence, re-scan the correct parameter.
*Disable Quick Keypad
Emulation
Feature/Option
* Indicates Default
To Next Page
Loading...
Need help?
General
