CHAPTER 5 SYMBOLOGIES
Introduction
This chapter describes symbology features and provides the programming bar codes for selecting these
features for the scanner. Before programming, follow the instructions in Chapter 1, Getting Started.
The scanner ships with the settings in Table 5-1 on page 5-2 (also see Appendix A, Standard Default
Parameters for all scanner defaults). If the default values suit requirements, programming is not necessary. Set
a feature value by scanning a single bar code or a short bar code sequences.
To return all features to default values, see Reset Factory Defaults on page 3-5. Throughout the programming
bar code menus, asterisks (
*) indicate default values.
Scanning Sequence Examples
In most cases, scan only one bar code to set a parameter value. For example, to transmit bar code data
without the UPC-A check digit, scan the
Do Not Transmit UPC-A Check Digit bar code under Transmit UPC-A
Check Digit on page 5-17. The scanner issues a fast warble beep and the LED turns green, indicating a
successful parameter entry.
Other parameters, such as Set Length(s) for D 2 of 5 require scanning several bar codes in sequence. See
the parameter description for this procedure.
NOTE Most computer monitors allow scanning the bar codes directly on the screen. When scanning from the
screen, be sure to set the document magnification to a level where the bar code can be seen clearly, and
bars and/or spaces are not merging.
*Enable UPC-A
(1)
Feature/Option
* Indicates Default
Option Value
To Next Page
Loading...
Need help?
General
