Zebra CS4070 User Manual

4 - 10 CS4070 Scanner Product Reference Guide
USB Keyboard FN 1 Substitution
Parameter # 1386
SSI # F8h 05h 6Ah
This option applies only to the USB Keyboard (HID) device. When enabled, this allows replacement of any FN1
characters in an EAN 128 bar code with a key category and value chosen by the user. See FN1 Substitution
Values to set the key category and key value.
FN1 Substitution Values
Key Category Parameter # 103
SSI # 67h
Decimal Value Parameter # 109
SSI # 6Dh
Enabling USB Keyboard FN 1 Substitution substitutes any FN1 character (0x1d) in an EAN128 bar code with a
value. This value defaults to 7013 (Enter Key).
When using host commands to set the FN1 substitution value, set the key category parameter to 1, then set
the 3-digit keystroke value. See Table H-1 on page H-1 for the desired value.
To select a FN1 substitution value via bar code menus:
1. Scan the bar code below.
2. Locate the keystroke desired for FN1 Substitution in Table H-1 on page H-1. Enter the 4-digit ASCII value
by scanning each digit in Appendix F, Numeric Bar Codes.
To correct an error or change the selection, scan Cancel.
Enable FN1 Substitution
(1)
*Disable FN1 Substitution
(0)
Set FN1 Substitution Value

Zebra CS4070 Specifications

General

Brand	Zebra
Model	CS4070
Category	Barcode Reader
Language	English