3 - 58 CS4070 Scanner Product Reference Guide
Wi-Fi Friendly Mode
Parameter # 1299
SSI # F8h 05h 13h
Scanners configured for Wi-Fi friendly mode behave as follows:
•
The scanner remains in sniff mode, and exits sniff mode only during firmware update.
•
If any Wi-Fi channel is excluded from the hopping sequence, AFH turns off.
•
Scanner (and dongle) avoid the selected Wi-Fi channels after establishing connection.
Notes
•
If using this feature, configure all scanners in the area for Wi-Fi friendly mode.
•
By default, no Wi-Fi channels are excluded.
•
Since Bluetooth requires a minimum of 20 channels when Wi-Fi channels 1, 6, and 11 are excluded,
a smaller number of channels are cut from the hopping sequence.
•
Updating Wi-Fi friendly settings before Bluetooth connection is recommended.
•
This mode is automatically disabled when connected to a Panasonic Toughpad.
Scan a one of the following bar codes to enable or disable Wi-Fi Friendly Mode, then see Wi-Fi Friendly
Channel Exclusion to select any channels to exclude.
*Disable Wi-Fi Friendly Mode
(0)
Enable Wi-Fi Friendly Mode
(1)
To Next Page
Loading...
Need help?
General
