User Preferences 3 - 53
Out of Range Electric Fence Trigger Timeout (continued)
Out of Range Electric Fence Alarm Timeout
Parameter # 1428
SSI # F8h 05h 94h
Scan one of the following bar codes to set the amount of time the alarm sounds once triggered.
3 Minutes
(6)
5 Minutes
(7)
NOTE The alarm shuts down under any one of the following conditions:
• This Out of Range Electric Fence Timeout occurs.
• You hold the minus button for greater than three seconds and then release it.
• The scanner comes back into range.
• The scanner is placed into Standard Batch Mode, an Out of Range Batch Mode, or a Batch Only Mode.
• The scanner is connected to a new host.
This alarm is disabled if the scanner is placed into a Batch Mode on page 3-44.
*3 Seconds
(0)
5 Seconds
(1)
To Next Page
Loading...