Radio Communications 5 - 31
Batch Mode
Parameter # 544
SSI # F1h 20h
The digital scanner supports five versions of batch mode. When the digital scanner is configured for any of the
batch modes, it attempts to store bar code data (not parameter bar codes) until transmission is initialized, or the
maximum number of bar codes are stored. When a bar code is saved successfully, a good decode beep sounds
and the LED flashes green. If the digital scanner is unable to store a new bar code, a low/high/low/high out of
memory beep sounds. (See page 2-1 for all beeper and LED definitions.)
In all modes, calculate the amount of data (number of bar codes) the digital scanner can store as follows:
Number of storable bar codes = 30,720 bytes of memory / (number of characters in the bar code + 3).
Connection Maintenance Interval (continued)
Set Interval to 8 Hours
(5)
Set Interval to 24 Hours
(6)
Set Interval to Forever
(7)
IMPORTANT Batch mode does not apply to SPP Slave Mode.
NOTE If the batch mode selection is changed while there is batched data, the new batch mode takes
effect only after all the previously batched data is sent
.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
