CHAPTER 6 SIGNATURE CAPTURE
PREFERENCES
Introduction
You can program the digital scanner to perform various functions, or activate different features. This chapter
describes signature capture preference features and provides programming bar codes for selecting these features.
The digital scanner ships with the settings shown in Table 6-1 on page 6-2 (also see Appendix A, Standard Default
Parameters for all defaults). If the default values suit requirements, programming is not necessary.
Setting Parameters
To set feature values, scan a single bar code or a short bar code sequence. The settings are stored in non-volatile
memory and are preserved even when the imager powers down.
To return all features to default values, scan the Set Factory Defaults on page 4-5. Throughout the programming
bar code menus, asterisks (
*) indicate default values.
NOTE Although the DS2278 digital scanner supports signature capture, the quality of the image is not
guaranteed. If the image does not meet your needs it is recommended that you upgrade to a DS8178
scanner.
NOTE Most computer monitors allow scanning bar codes directly on the screen. When scanning from the screen,
be sure to set the document magnification to a level where you can see the bar code clearly, and bars
and/or spaces do not merge.
*Enable Parameter
(1)
Feature/option
* Indicates default
Option value
To Next Page
Loading...
Need help?
General
Weight and Dimensions
