12 - 2 DS2278 Digital Scanner Product Reference Guide
Scanning Sequence Examples
In most cases, scanning one bar code sets the parameter value. For example, to transmit bar code data without the
UPC-A check digit, scan the Do Not Transmit UPC-A Check Digit bar code under Transmit UPC-A Check Digit
on page 12-18. The scanner issues a fast warble beep and the LED turns green, signifying a successful parameter
entry.
Other parameters, such as Set Lengths for D 2 of 5, require scanning several bar codes. See the parameter
descriptions for this procedure.
Errors While Scanning
Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.
Symbology Parameter Defaults
Table 12-1 lists defaults for all symbology parameters. Change these values in one of two ways:
• Scan the appropriate bar codes in this chapter. The new value replaces the standard default value in
memory. To recall the default parameter values, see Default Parameters on page 4-5.
• Configure the scanner using the 123Scan
configuration program. See Chapter 12, Symbologies.
NOTE See Appendix A, Standard Default Parameters for all user preference, host, symbology, and
miscellaneous default parameters.
Table 12-1 Symbology Parameter Defaults
Parameter
Parameter
Number
1
SSI Number
2
Default
Page
Number
Enable/Disable All Code Types
12-8
1D Symbologies
UPC/EAN/JAN
UPC-A 1 01h Enable 12-9
UPC-E 2 02h Enable 12-9
UPC-E1 12 0Ch Disable 12-10
EAN-8/JAN 8 4 04h Enable 12-10
EAN-13/JAN 13 3 03h Enable 12-11
Bookland EAN 83 53h Disable 12-11
Bookland ISBN Format 576 F1h 40h ISBN-10 12-12
ISSN EAN 617 F1h 69h Disable 12-12
1. Parameter number decimal values are used for programming via RSM commands.
2. SSI number hex values are used for programming via SSI commands.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
