Symbologies 12 - 43
Code 11
Parameter # 10
SSI # 0Ah
Scan one of the following bar codes to enable or disable Code 11
Set Lengths for Code 11
L1 = Parameter # 28
SSI # 1Ch
L2 = Parameter # 29
SSI # 1Dh
The length of a code refers to the number of characters (i.e., human readable characters), including check digit(s)
the code contains. Set lengths for Code 11 to any length, one or two discrete lengths, or lengths within a specific
range. Minimum and maximum length range is from 0 - 55. The default minimum and maximum length range is
from 4 - 55.
Scan one of the following bar codes to select a length option:
• One Discrete Length - Decode only Code 11 symbols containing a selected length. Select the length using
the bar codes in Appendix G, Numeric Bar Codes. For example, to decode only Code 11 symbols with 14
characters, scan Code 11 - One Discrete Length, and then scan 1, 4. To correct an error or change the
selection, scan Cancel on page G-3.
Enable Code 11
(1)
*Disable Code 11
(0)
NOTE The maximum number of 1D bar code characters readable with scanner depends on the type of
symbology, type of characters (i.e., digits or letters), printing density, and quality. For reference, the
DS2278 reads 3.1 in wide, 10mil 1D bar codes printed with 1200dpi resolution and 80% contrast.
NOTE When setting lengths, enter a leading zero for single digit numbers.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
