NETWORK Installations Only:
To meet regulatory requirements for user safety, Ethernet “Network” connectivity is the only method
recommended for attaching the HP LaserJet printer to the system.
In this configuration a direct cable connection will be used between the printer and the z.one
pro
(using
a “crossover cable”). The generic IP Address setup in the printer will need to be entered into the
corresponding report printer configuration page on the system.
To find out the IP Address currently setup as a factory default in the HP LaserJet printer, perform the
following steps:
1. With the printer powered ON, the z.one
pro
powered ON, and the crossover cable connected
between the two devices, perform the following step.
2. On the HP printer, press and hold (for 5 seconds), the “GO” button
3. A series of pages of internal configuration information about the printer should print out.
4. Check the IP Address value that appears on the Networking Info page
5. Enter this value into the PRINTER IP ADDRESS field, on the Export/Report Configuration
page
NOTE: For configurations where printer is being attached to an existing DICOM network
that is running on the system, the IP Address assigned by the IT Administrator of the network
at the site will need to provide this IP Address. This IP Address will need to be setup using the
HP Toolbox setup software on a PC, that is temporarily connected to the HP LaserJet printer.
That IP Address will also have to be entered in the Export/Print configuration page on the
system.
6. ............................................ In order for the z.one
pro
to communicate with the HP LaserJet
printer, it must be on the same subnet. This is accomplished by programming an IP Address
into the z.one
pro
(on the System Setup -> Network page) that is one value greater then the IP
Address of the HP LaserJet printer.
To configure this IP Address into the system
1. Go to the “NETWORK CONFIGURATION” page on the z.one
pro
by executing the following
sequence:
System Setup ->Archive-> Network
To Next Page
