Cloth with thread made of steel
Other coarse tools
Do not autoclave, immerse, or attempt to sterilize the LCD display.
To Clean Front Glass
1. Before cleaning, turn off the AC circuit breaker on the z.one
pro
system to remove all power
from the unit.
2. Clean the glass using a soft cotton cloth lightly moistened with a watery solution or a mild
commercial glass-cleaning product suited for coated glass surfaces.
CAUTION: Spray cleaning solution on the cloth, NOT on the display.
3. Wipe dry with a clean, dry, soft, lint-free cloth.
To Clean External Case
1. Before cleaning, turn off the AC circuit breaker on the z.one
pro
system to remove all power
from the unit.
2. Wipe the z.one
pro
system surfaces with a safe disinfectant solution such as Sani-Cloth Plus
or isopropyl 50% alcohol and follow the disinfectant label instructions for use.
3. Repeat with water only.
4. Wipe dry with a clean, dry, soft cloth.
WARNING: Do not expose the external case of the LCD display to any of the following
agents:
Cidex
Betadine
General z.one
pro
Exterior Surface Cleaning
Do not use disinfectants (such as gluteraldahyde or hydrogen peroxide) or acetone to clean
any surfaces on the z.one
pro
system or its accessories.
Before cleaning, turn off the AC circuit breaker on the z.one
pro
system to remove all power
from the unit.
Wipe the z.one
pro
surfaces with a safe disinfectant solution such as Sani-Cloth Plus or
isopropyl 50% alcohol and follow the disinfectant label instructions for use.
Do not autoclave, immerse, or attempt to sterilize the LCD display or transducers.
Do not spill or spray liquid directly on the control panel, LCD display, battery charger, AC
power adapter, or transducer connector.
Using soap and water or a mild disinfectant, gently wipe the surfaces of the z.one
pro
system
with a moistened cloth.
To Next Page
