Aastra AXD User Manual

AMT/PTD/PBX/0058/4/6/EN Installation and Maintenance Manual - Aastra 5000
Page 342 01/2011 Installation and activation
The screen below opens, asking whether the administration network must be configured
in case of administration and telephony flow separation.
If this configuration is not necessary, answer "
n" and confirm with the "Return" key to go
to the next screen concerning the service status.
If this configuration is necessary in this phase, see the specific document
: Operating
manual for telephony and administration flow separation -
AMT_PTD_PBX_0101.
The licence number declaration screen is then displayed.
• Enter the corresponding value (optional: it may be entered later from AMP).
•Press "Return" to confirm, after entering "
y" or "n".
The system’s PARI number configuration screen is displayed:
• If you answer YES, "
y", the next screen allows you to redefine this number.
• Enter the corresponding value.
•Press "Return" to confirm, after entering "
y" or "n".
The status of FTP, TMA and DHCP services can be modified on the following screens.
Refer to Section 6.2.
DO YOU WANT TO CONFIGURE MANAGEMENT IP NETWORK ? Y/[N]
Aastra 5000 Configuration
/ Licence
*-----------------------------------------------
--*
| Licence: |
*-----------------------------------------------
--*
Do you want to change configuration Y(es)/N(o) ? n
AASTRA 5000 CONFIGURATION / CONFIGURATION/PARI
*-------------------------------------------------*
|PARI: 123456789 |
DO YOU WANT TO CONFIGURE PARI (Y/N): Y

Aastra AXD Specifications

General

Brand	Aastra
Model	AXD
Category	Server
Language	English