AMT/PTD/PBX/0058/4/6/EN Installation and Maintenance Manual - Aastra 5000
Page 462 01/2011 INSTALLING A5000 SERVER (Non-redundant)
pressing "y" or "n".
5 Installing the services
This menu is used to install the following services:
• DHCP
• FTP
• TFTP
•SYSLOG
If you wish to manage any of these services, you must install it in advance. Installing the
service enables you to modify its status and configuration later via AMP.
The FTP service (accounts and storage directories) is automatically configured when the
FTP service is started by AMP. There is no automatic action on A5000 Server like on
Aastra X series systems if the FTP and TMA services are started at the same time.
The TFTP service is automatically configured when the TFTP service is started by AMP.
The menu Telephony service > System > Software maintenance > Tftp: loading of files is
only accessible if the TFTP service is installed. This menu is used to place the firmware
of terminals A6xxd, 312i and DECT-IP base stations (RFPs) in the TFTP server storage
directory.
The SYSLOG service is configured manually and via the menu:
Telephony service > System > Expert > Acces processor > Debug tool> Traces >
Parameters. The IP address configuration is only accessible if the SYSLOG service is
installed and if the "step-by-step output" line is validated.
The DHCP service is configured manually and via the DHCP service. There is no DHCP
server preconfiguration on A5000 Server like on Aastra X series system. In a redundant
A5000 Server configuration, the DHCP service cannot be installed and managed by AMP.
In this case, it is managed directly by the operating system Red Hat.
• To install a service, press "y". The next screen is used to modify the value of the DHCP,
FTP, TFTP and SYSLOG fields. The values entered must be 0 (service not installed) or
1 (service installed).
• Validate the modifications with the "Return" key, after confirming or rejecting them by
pressing "y" or "n".
To Next Page
Loading...
Need help?
General
