Setting the voltage range of the auxiliary control voltage
transformer (T21)
Connect the power supply wires of the auxiliary control voltage transformer according to
the power network voltage.
Connecting a PC
A PC (with eg, the Drive composer PC tool) can be connected as follows:
1. Connect an ACx-AP-x control panel to the unit either
• by inserting the control panel into the panel holder or platform (if present), or
• by using an Ethernet (eg, Cat 5e) networking cable.
2. Remove the USB connector cover on the front of the control panel.
3. Connect an USB cable (Type A to Type Mini-B) between the USB connector on the
control panel (3a) and a free USB port on the PC (3b).
4. The panel will display an indication whenever the connection is active.
?
Start
Stop
Loc/Rem
?
Start
Stop
Loc/Rem
USB connected
3a
4
3b
2
2
5. See the documentation of the PC tool for setup instructions.
Electrical installation 111
To Next Page
Loading...
