Layout
1
A
B
C
D
E
F
2 3 4 5 6 7 8
A
B
C
D
E
F
Original drawing made with 3D CAD. Set the correct scale factor when adding dimensions after DWG/DXF conversion.First angle projection.
31 1.20[ ]
109 4.28[ ]
59 2.31[ ]
71 2.79[ ]
3AXD50000182008 -.2+
We reserve all rights in this document and in the information contained therein. Reproduction,
use or disclosure to third parties without express authority is strictly forbidden.
© ABB Oy. PROPRIETARY AND SECRET INFORMATION. CONFIDENTIAL
3AXD50000137442 (ASSEM) D.0+
Based on Prepared
A.Piirainen 04-Oct-17
Title
DIMENSION DRAWING
Doc. des. Scale Form
Customer Check.
P.Viitala 04-Oct-17 CBAI-01 DIMENSION DRAWING
DIMENSION DRAWING 1:1 A4
Appr.
J.Viman 04-Oct-17
Resp.dept. Rev.ind.
-.2 (DR)
Lang.
EN
Cust. Doc. No. Project name Doc. No.
3AXD50000182008
Sheet
1
DMS Number
3AXD10000653563
Weight kg
0.11
Total
1
A
Initial Approval 04-Oct-17 A.Piirainen
Terminal designations (page 261)
Analog output 31
Terminal designations (page 261)
Analog input 32
Analog output scale switch: (page 265)
Analog output scale switch3
-Grounding hole4
-Control unit interface (slot 2)5
Diagnostics (page 263)
Diagnostic LED6
Terminal designations (page 261)
Analog output 47
Terminal designations (page 261)
Analog input 48
￭ Mechanical installation
Necessary tools and instructions
• Screwdriver and a set of suitable bits.
Unpacking and checking the delivery
1. Open the option package. Make sure that the package contains:
• CBAI-01 bipolar analog IO extension module
• a mounting screw.
2. Make sure that there are no signs of damage.
Installing the module
Note:
Frame R1: Do not install this module before you have installed the power cables as it would
cover the power terminals.
See section Installing optional modules in chapter Electrical installation.
260 Optional I/O extension modules
To Next Page
Loading...
