ABB ACS580-07 - Fault tracing

SeeTask
Routing the cables (page 75)
Route the cables.
Checking the insulation of the
motor and motor
cable (page 96)
Check the insulation of the supply cable, the motor and the motor cable.
Connecting the power
cables (page 90), Connecting
the control cables (page 104)
Connect the power cables.
Connect the control cables.
Installation checklist of the
drive (page 129)
Check the installation.
Start-up (page 131)
Start the drive up.
Start-up (page 131) and firmware
manual
Operate the drive: start, stop, speed control etc.
Terms and abbreviations
DescriptionTerm/
Abbreviation
Bipolar analog IO extension moduleCBAI-01
Type of control unitCCU-24
115/230 V digital input extension moduleCHDI-01
Multifunction extension module (external 24 V AC/DC and digital I/O extension)CMOD-01
Multifunction extension module (external 24 V AC/DC and isolated PTC interface)CMOD-02
Multifunction extension module (external 24 V and ATEX-certified PTC interface)CPTC-02
Electromagnetic compatibilityEMC
BACnet/IP adapter moduleFBIP-21
Optional CANopen® adapter moduleFCAN
Optional ControlNet™ adapter moduleFCNA-01
DDCS communication module with two pairs of 10 Mbit/s DDCS channelsFDCO-01
Optional DeviceNet™ adapter moduleFDNA-01
Optional EtherCAT® adapter moduleFECA-01
Optional Ethernet adapter module for EtherNet/IP™, Modbus TCP® and PROFINET IO®
protocols
FENA-11
Optional Ethernet adapter module for EtherNet/IP™, Modbus TCP® and PROFINET IO®
protocols, 2-port
FENA-21
Optional Ethernet POWERLINK adapter moduleFEPL-01
Optional PROFIBUS DP® adapter moduleFPBA-01
Physical size of the drive or power moduleFrame, frame
size
Insulated gate bipolar transistorIGBT
Safe torque off (IEC/EN 61800-5-2)STO
Introduction to the manual 29