ABB ACS580-07 - Materials

Materials
Hot-dip zinc coated 1.5 mm thick steel sheet (thickness of coating approximately
20 micrometers). Polyester thermosetting powder coating (thickness approximately
80 micrometers) on visible surfaces, color RAL 7035 and RAL 9017.
Cabinet
Tin-plated copperBusbars
Inlet (door): airComp 300-50 240 mm x 286 mm (ABB code 3AXD50000037880)Air filters of IP54 drives
Insulating materials and non-metallic items mostly self-extinctiveFire safety of materials
(IEC 60332-1)
Standard package:Package
• plywood, wet strength heavy duty cardboard, polyethylene sheet (thickness0.15
mm), stretch film (thickness 0.023 mm), PP tape, PET strap,sheet metal (steel)
• for land and air transport when planned storage time is less than 2 months or
when storage can be arranged in clean and dry conditionsless than 6 months
Seaworthy package:
• plywood, wet strength heavy duty cardboard (or plywood with specialrequest),
VCI sheet film (PE, thickness 0.10 mm), VCI stretch film(PE, thickness 0.04
mm), VCI emitter bags, PP tape, PET strap, sheetmetal (steel)
• for sea transport in containers
• recommended for land and air transport when storage time prior to installation
exceeds 6 months or storage is arranged in partially weather-protected conditions
Plywood package on special request
Cabinets are attached to the pallet with screws and braced from the bottom end
to prevents swaying inside the package.
Transportation packaging:
• R6...R9 cabinets can be stacked (2 pieces) and transported horizontally.
• R10...R11 cabinets are transported vertically.
For drives with empty cabinet (options +C196 to +C201)
Standard package:
• timber, polyethylene sheet (thickness 0.15 mm), stretch film (thickness 0.023
mm),PP tape, PET strap, sheet metal (steel)
• for land and air transport when planned storage time is less than 2 months or
when storage can be arranged in clean and dry conditions less than 6 months
• can be used when products will not be exposed to corrosive atmosphere during
transport or storage
Seaworthy package:
• timber, plywood, VCI sheet film (PE, thickness 0.10 mm), VCI stretchfilm (PE,
thickness 0.04 mm), VCI emitter bags, PP tape, PET strap,sheet metal (steel)
• for sea transport with or without containerization
• for long storage periods in environments where roofed and humidity-controlled
storagecannot be arranged
For handling the packages, see section Moving and unpacking the drive (page 53).
The main parts of the drive can be recycled to preserve natural resources and
energy. Product parts and materials should be dismantled and separated.
Disposal
Generally all metals, such as steel, aluminum, copper and its alloys, and precious
metals can be recycled as material. Plastics, rubber, cardboard and other packaging
material can be used in energy recovery. Printed circuit boards and large electro-
lytic capacitors need selective treatment according to IEC 62635 guidelines. To
aid recycling, plastic parts are marked with an appropriate identification code.
Contact your local ABB distributor for further information on environmental aspects
and recycling instructions for professional recyclers. End of life treatment must
follow international and local regulations.
214 Technical data