ABB ACS580-07 - Installing the Module; Electrical Installation; Necessary Tools and Instructions; Terminal Designations

Note:
The support part is needed for the following frame R1 drive types -02A7, -03A4,
-04A1, -05A7, -08A5 and -12A7.
3. Make sure that there are no signs of damage.
Installing the module
See section Installing optional modules in chapter Electrical installation.
￭ Electrical installation
WARNING!
Obey the instructions in chapter Safety instructions. If you ignore them, injury or
death, or damage to the equipment can occur. If you are not a qualified electrician,
do not do electrical work.
Make sure that the drive is disconnected from the input power during
installation. If the drive is already connected to the input power, wait for
5 minutes after disconnecting the input power.
Necessary tools and instructions
• Screwdriver and a set of suitable bits
• Cabling tools
Terminal designations
For more detailed information on the connectors, see section Technical data (page 270).
Relay outputs
DescriptionMarking
Common, CRO4C50
Normally closed, NCRO4A51
Normally open, NORO4B52
Common, CRO5C53
Normally closed, NCRO5A54
Normally open, NORO5B55
115/230 V inputs
DescriptionMarking
115/230 V input 1HDI770
115/230 V input 2HDI871
Neutral point
NEUTRAL
1)
72
115/230 V input 3HDI973
115/230 V input 4HDI1074
Neutral pointNEUTRAL
1)
75
115/230 V input 5HDI1176
115/230 V input 6HDI1277
Optional I/O extension modules 267