ABB ACS580-07 - Fuses for Branch Circuit Protection

The drive with option +F289 is equipped with standard fuses listed below for internal circuit
protection. The fuses restrict drive damage and prevent damage to adjoining equipment in
case of a short-circuit inside the drive. The drive also requires external fuses for branch
circuit protection per NEC, see section Fuses for branch circuit protection (page 178).
Fuse (one fuse per phase) with option +F289Input current
A
Drive type
ACS580-07-
SizeTypeManufacturerA
U
N
= 480 V
1170M3416Bussmann2501240145A-4
1170M3416Bussmann2501560169A-4
1170M4410Bussmann3151800206A-4
2170M5408Bussmann4002400246A-4
2170M5410Bussmann5002600293A-4
3170M6410Bussmann6303610363A-4
3170M6411Bussmann7004140430A-4
Note 1: See also Implementing the emergency stop function (page 82).
Note 2: Fuses with higher current rating than the recommended ones must not be used.
Fuses with lower current rating can be used.
Note 3: Fuses from other manufacturers can be used if they meet the ratings and the melting
curve of the fuse does not exceed the melting curve of the fuse mentioned in the table.
Note 4: Circuit breakers must not be used without fuses.
Fuses for branch circuit protection
The drive is suitable for use on a circuit capable of delivering not more than 100,000 rms
symmetrical amperes at 480 V maximum when the input cable is protected with UL class
T or L fuses. The fuses for branch circuit protection per NEC must be selected according
to the table below. Fast acting class T and L or faster are recommended in the USA. Obey
local regulations.
NEC typeFuse (one fuse per phase)Input
current
A
Drive type
ACS580-07-
UL
class
TypeManufacturerVA
U
N
= 460 V
0124A-4TJJS-200Bussmann6002001240145A-4
0156A-4TJJS-225Bussmann6002251560169A-4
0180A-4TJJS-300Bussmann6003001800206A-4
0240A-4TJJS-350Bussmann6003502400246A-4
0260A-4TJJS-400Bussmann6004002600293A-4
0361A-4TJJS-500Bussmann6005003610363A-4
0414A-4TJJS-600Bussmann6006004140430A-4
178 Technical data