ABB ACS580-07 - Start-Up; Setting the Parameters; Diagnostics; Faults and Warning Messages

￭ Start-up
Setting the parameters
1. Power up the drive.
2. If no warning is shown,
• make sure that the values of both parameters 15.02 and 15.01 are CMOD-02.
If warning A7AB Extension I/O configuration failure is shown,
• make sure that the value of parameter 15.02 is CMOD-02.
• set the parameter 15.01 value to CMOD-02.
You can now see the parameters of the extension module in parameter group 15 I/O
extension module.
￭ Diagnostics
Faults and warning messages
Warning A7AB Extension I/O configuration failure.
LEDs
The extension module has one diagnostic LED.
DescriptionColor
The extension module is powered up.Green
￭ Technical data
Dimension drawing:
The dimensions are in millimeters and [inches].
284 Optional I/O extension modules