ABB ACS580-07 - Replacing the Drive Module Main Fans (Frames R6 to R8)

a
4
3
b
6
￭ Replacing the drive module main fans (frames R6 to R8)
WARNING!
Obey the instructions in chapter Safety instructions. If you ignore them, injury or
death, or damage to the equipment can occur.
1.
Stop the drive and do the steps in section Electrical safety precautions (page 20) before
you start the work.
2. Open the cabinet door.
3.
Remove the drive module from the cabinet as described in section Replacing the drive
module (frames R6 to R9) (page 148).
4. Remove the two mounting screws of the fan mounting plate at the bottom of the drive
module.
5. Unplug the fan power supply wires from the drive.
6. Pull the fan mounting plate down from the side edge.
7. Unplug the fan power supply wires from the drive.
8. Lift the fan mounting plate off.
9. Remove the fan from the mounting plate.
144 Maintenance