ABB CRB 15000 - Page 213

Refitting the base cabling
Use these procedures to refit the base cabling.
Refitting the base cabling
NoteAction
xx2100000408
Insert the cabling into the base.1
xx2100000409
Orient the base connector so that it points to the
right, seen from back of the robot.
2
Hex socket head cap screw: M3x8
12.9 Lafre 2C2B/FC6.9 (4 pcs).
Secure the base connector with the attachment
screws.
3
Tightening torque: 0.8 Nm.
xx2100000406
Continues on next page
Product manual - CRB 15000 213
3HAC077389-001 Revision: L
© Copyright 2021 - 2023 ABB. All rights reserved.
5 Repair
5.3.1 Replacing the base cabling
Continued