ABB CRB 15000 - Page 88

Fastener quality for hex spacers
The following table shows the requirements on hex spacers for fitting equipment
on the upper arm covers.
xx2300000930
CRB 15000-10/1.52
CRB 15000-12/1.27
CRB 15000-5/0.95
Stainless steel 4.8, or higherStainless steel 4.8, or higherMaterial
0.6 Nm+/-5%0.6 Nm+/-5%Tightening torque
10 mm8 mmMinimum thread length (a)
10 mm8 mmThread length (b)
5 mm5 mmScrew head width (S)
25 mm18 mmLength (L)
Bossard, article number:
304325041152
Bossard, article number:
304318041152
Example of suitable hex
spacer
Bossard, article number:
304330041152
Keystone, article number:
24289~24294
Continues on next page
88 Product manual - CRB 15000
3HAC077389-001 Revision: L
© Copyright 2021 - 2023 ABB. All rights reserved.
3 Installation and commissioning
3.3.8 Fitting equipment on the robot (robot dimensions)
Continued