Removing the joint cable
NoteAction
ELECTROSTATIC DISCHARGE (ESD)
The unit is sensitive to ESD. Before handling the
unit read the safety information in section The
unit is sensitive to ESD on page 53.
1
Protection plate: 3HAC077790-001
(for CRB 15000-5/0.95) /
3HAC087789-001 (for CRB 15000-
10/1.52 and CRB 15000-12/1.27)
Fit the protection plate to the drive board unit.
Tip
Using the protection plate is important for protect-
ing the drive board unit. If complete joint unit is
to be replaced, the protection plate is not needed.
2
xx2000002057
xx2000002058
Cut the cable tie at the drive board.3
Continues on next page
Product manual - CRB 15000 887
3HAC077389-001 Revision: L
© Copyright 2021 - 2023 ABB. All rights reserved.
5 Repair
5.6.4 Replacing the axis-2 joint unit (CRB 15000-10/1.52 and CRB 15000-12/1.27)
Continued
To Next Page
Loading...
