12 | XSE RI ES G5 | 210602 6MNAA
NOTICE – Equipment damage or loss of data. This symbol indicates a potential for
equipment damage, loss of data or another unintended outcome. Failure to observe this
information may result in damage to or destruction of the product and / or other system
components.
IMPORTANT NOTE: This symbol indicates operator tips, particularly useful information, or
important information about the product or its further uses.
The XFC
G5
and XRC
G5
use nominal 12 Vdc voltages in the range of 9 Vdc to 15.5 Vdc. There are no
hazardous voltages present in the device. However, some optional power sources may convert power
from Vac to Vdc.
Pressurized natural gas is present in the measurement pipeline. Natural gas may escape from the
pipeline during installation, calibration, or following damage to the pipeline. Only properly trained and
authorized personnel should work in hazardous locations.
There are no chemical or burn hazards. Personal Protection Equipment is not required
WARNING – Bodily injury: Apply power only after the procedures are complete. Technicians
must perform the procedures in order: plan, install, wire, verify the power-on sequence, and
configure.
WARNING – Bodily injury: Read and follow instructions contained in this guide and on
warning tags on the equipment before and during equipment installation. Failure to do so
could result in bodily injury or equipment damage.
WARNING – Bodily injury: Ensure there is no hazardous atmosphere present when
performing maintenance on the unit. Do not separate components when energized. This
applies to all connectors and connections, cabling and wiring.
WARNING – Equipment damage: Potential electrostatic charging hazard: clean only with
damp cloth.
To Next Page
Loading...
Need help?
General
