21060 26M N AA | X SER IE S
G5
| 71
Figure 8-18: Network connections
When prompted, provide the security passcode and click OK.
View the list of wireless networks again and verify that the client shows Connected. A
connected status indicates that the Wi-Fi client has been authenticated and automatically
assigned an IP address.
Verify connection from PCCU:
Start a new instance of PCCU or close the current PCCU connection. The main PCCU screen
displays.
On the PCCU toolbar, click Setup.
On the Setup tab, for Communications/PCCU Connect Method, select TCP/IP.
In the Network ID or IP field, type the IP address assigned to the XFC
G5
or XRC
G5
for the
Wi-Fi network (default: 192.168.1.1).
Click Close to exit PCCU setup and return to the main PCCU screen.
On the PCCU toolbar, click Entry and verify connection is established.
8.7.6 Enable Bluetooth
The XFC
G5
and XRC
G5
support Bluetooth functionality to allow wireless local access. This procedure
enables onboard Bluetooth.
For additional details, or if using a USB dongle, click Help from the Bluetooth tab screen.
Enable onboard Bluetooth:
Ensure the antenna has been installed. See section 3.12 Install antenna.
Configure the Network ID. See section 8.7.3 Configure for network communication.
On the Entry mode navigation tree, select Communications.
Select the Bluetooth tab.
For the Bluetooth mode, select On-board.
Click Send.
Click Yes to confirm. Wait for Bluetooth to initialize.
Verify that the Bluetooth Status displays Ready.
To Next Page
Loading...
Need help?
General
