Abbott CELL-DYN 3200 - Page 264

5-112
CELL-DYN
®
3200 System Operator’s Manual
9140181H—October 2001
Operating Instructions
Using The Work List
Section 5
Use the arrow keys to move the cursor to the desired field. Use the[TOGGLE ON/
OFF]key to change an option and advance the cursor to the next field.
ON/OFF Fields
Turning fields ON or OFF in this screen affects the movement of the cursor in the
WORK LIST screen when the operator makes entries to the Work List.
1. When the operator enters data into a <Work List> field and presses the Enter
key, the cursor will move to the next field that was turned ON in the WORK
LIST SET UP screen, skipping any intervening fields that were left OFF.
2. For example:
a. Only the <Dr Name> field in the WORK LIST SET UPscreen was turned
ON, and
b. The operator is making new patient entries into the Work List.
In this case, when the operator enters data in the <Specimen ID> field and
presses the Enter key, the cursor goes to the next ON field, which in this
example is Dr Name. All intervening fields are skipped.
NOTE: OFF fields will still accept data. The operator can use the arrow
keys to move the cursor to an OFF field and input data. Pressing the
Enter key saves the data and moves the cursor to the next ON field.
Number Fields
The system will accept any number in the range 1 to 6 for Patient Limits and 1 to
4 for Parameter Set. The number selected for either field serves as the default for
that field for subsequent entries and is independent of whether that field is ON or
OFF.
For example:
1. If the <Patient Limits> field is OFF but the default setting is changed to 6,
then 6 will be displayed as the default setting on the Work List.
2. Because the <Patient Limits> field is OFF, the cursor will bypass this field in
the Work List.
3. If the <Patient Limits> field were ON, the cursor in the Work List would stop
in this field, allowing the operator to select a different setting, such as 2, for
that entry. The next entry would continue to display the default setting, which
in this example is 6.
NOTE: Regardless of the default value for either the <Limit Set> or
<Parameter Set> fields, the operator can use the arrow keys to
move the cursor to the field and enter another value. This new value
will affect only that entry. All previous entries will retain their
original settings, and all subsequent entries will use the default
setting selected in the WORK LIST SET UP menu.