Abbott CELL-DYN 3200 - Page 292

5-140
CELL-DYN
®
3200 System Operator’s Manual
9140181H—October 2001
Operating Instructions
Using The Data Log
Section 5
6. Repeat steps 3–5 until all selections have been made.
7. If desired, press the Print Screen key on the keyboard to obtain a printout of
the selected groups.
8. Press [RETURN] to return to theDATA LOGscreen.
9. The Data Log is displayed configured with the selected parameters.
Standard Groups
The Data Log display may also be customized with pre-determined groups
(Standard Groups) of parameters using the [STANDARD GROUPS] key. Figure 5.54
shows the WBC Group placed in GROUP 1, the RBC Group placed in GROUP 2,
the PLT Group placed in GROUP 3 and the Diff Group placed in GROUP 4.
To Customize the Data Log Display for Standard Groups
1. From the mainDATA LOGscreen, press [CUSTOMIZE DATA LOG]to display the
CUSTOMIZE DISPLAY FOR DATA LOGscreen.
2. Press [STANDARD GROUPS] to display the CUSTOMIZE DISPLAY FOR DATA
LOGscreen and key labels for Standard Groups.
3. Use the Arrow keys on the keyboard to move the cursor to the desired group
(1–4) location.
NOTE: This number indicates the order in which the group of parameters
will be displayed (Group 1 on the first screen, Group 2 on the
second, etc.).
4. Press the soft key corresponding to the desired parameter group. This group
is displayed in the position indicated by the cursor.
5. Repeat steps 3 and 4 until all desired groups have been selected.
6. If desired, press the Print Screen key on the keyboard to obtain a printout of
the configuration.
7. Press [RETURN] to return to theDATA LOGscreen.
8. The Data Log is displayed configured with the standard groups of
parameters.