10-8
CELL-DYN
®
3200 System Operator’s Manual
9140181H—October 2001
Troubleshooting and Diagnostics
Diagnostics Menu
Section 10
Figure 10.7 WOC Count Rate Graph
Clear Faults
When the [CLEAR FAULTS] key is pressed, the Analyzer returns to the READY state
if the corrective action taken resolved the problem. If the corrective action did not
correct the problem, the fault status does not change.
NOTE: Only operator correctable faults can be cleared with the [CLEAR FAULTS]
key.
To Next Page
Loading...
