7352 Series Digital Multimeter Operation Manual
2. PRECAUTIONS
2-1
2. PRECAUTIONS
This chapter describes precautions when using this instrument. Read this chapter before using this instru-
ment.
CAUTION: Using this instrument while it is stood on end or stacked with other products is unstable and danger-
ous.
Do not push or place heavy loads on this instrument.
2.1 If a Fault Occurs
If any smoke, smell, or noise emanates from this instrument, disconnect this instrument from the power sup-
ply by removing the power cable. Contact an ADC CORPORATION sales representative immediately.
2.2 Removing the Case
The case of this instrument should only be opened by ADC CORPORATION service engineers.
WARNING: This instrument contains high-voltage and high temperature parts which may cause electrical shocks
or burns.
2.3 Power Fuse
This instrument is protected from overcurrent by a power fuse.
The power fuse, which is located on the rear panel, cuts the power supply if an overcurrent flows. If the power
fuse was blown, remove the power cable and separate between the power supply and this instrument. There
may be some problems in this instrument and request an ADC CORPORATION sales representative to repair
it.
To Next Page
Loading...
