ADCMT 7352A User Manual

7352 Series Digital Multimeter Operation Manual
8.9 System Recovery Procedure
8-18
8.9 System Recovery Procedure
Initialization
The following describes how to initialize the setting parameters.
1. Select from the mode and press to enter the selection
layer.
2. The ‘PARAM’ parameter is displayed. Press to enter the entry layer.
3. Press while ‘DFLT’ is displayed.
The parameters can be initialized by selecting and executing ‘DFLT’ when loading the
parameter setting.
For more information on how to initialize the parameters, refer to Section 5.10, “Sav-
ing and Loading the Measurement Condition Settings.”
Initial value when shipping
The following describes how to set all parameters except for the calibration value and
calibration memo to the values when shipping.
1. Turn on the power while pressing the and keys.
Quitting MENU
Press to quit the operation in MENU.
MENU is closed even if any layer in MENU is operated.
NOTE: Changing parameters, which are not appliedd by pressing , is
canceled.
Initial value
The list of conditions, under which the setting parameters are initialized, and initial
values are shown in Table 8-5.
INIT
MENU
ENTER
NULL
UP
EXIT
ENTER

ADCMT 7352A Specifications

General

Brand	ADCMT
Model	7352A
Category	Multimeter
Language	English