7352 Series Digital Multimeter Operation Manual
3. SETUP
3-1
3. SETUP
This chapter describes how to set up this instrument on delivery. The following topics are covered in this
chapter.
3.1 Inspection on Delivery
3.2 Installation Environment
3.3 Accessories
3.4 Power Requirements
3.1 Inspection on Delivery
After receiving the product, inspect the outside and the accessories according to the following procedure.
1. Check that the shipping container and the cushioning material are not damaged.
IMPORTANT: If the shipping container or the cushioning material is damaged, keep them until the following
inspections are complete.
2. Check that the outside of the product is not damaged.
WARNING: If any outside components of the product such as the cover, panel (front or rear), power switch,
or connector are damaged, do not turn on the power. Doing so may cause an electrical shock.
3. Check that the standard accessories listed in Table 3-1 are complete and not damaged.
If any of the following occur, contact ADC CORPORATION sales representative.
• The shipping container or the cushioning material is damaged, or signs of stress are found.
• The outside of the product is damaged.
• The standard accessories are incomplete or are damaged.
• Defects are found in the operation check.
To Next Page
Loading...
Need help?
General
