Installation of Safety Decals
1. Make sure that the installation surface is clean and dry.
2. Make sure that the temperature of the installation surface is not less than 5 °C (41 °F).
3. Find the correct position for the decal before you remove the backing paper.
4. Remove a small part of the cover paper.
5. Put the decal in the correct position on the installation surface and carefully push the small part of the
shown adhesive surface of the decal on to the installation surface.
6. Slowly remove the cover paper and attach the decal to the installation surface.
7. Make small air holes in the decal with a pin and use the cover paper to make sure that the decal is flat.
Maintenance of Safety Decals
Safety decals show important data and data that you can use that will help you to safely operate and
maintain the machine:
Obey the instructions to make sure that all the decals stay in the correct position and condition.
• Keep the safety decals clean and in good condition at all times. Clean the safety decals with soap and
water. Do not use mineral spirits, abrasive cleaners or other agents that can cause damage to the safety
decals
• Replace safety decals that are missing or that are in bad condition
• Purchase replacement safety decals from your local service provider.
1. Safety
22 Baler Wrapper Combination
4900.LE.EN01
To Next Page
Loading...
Need help?
General
