23
The Agilent 1100 Series Control Module
Control Module Keys
Navigation keys
These 5 keys [F1 - F5] allow you to switch between the menus. Within these menus
the relevant parameters can be set and certain functions can be accessed. The
Navigation keys always correspond to a button displayed above them on the screen.
The menus accessed via the buttons vary according to the screen you are working
with. In some cases pressing a button will cause a list box to appear. From there you
must make a choice in order to proceed.
Action keys
The 3 Action keys [F6-F8] trigger a variety of functions. The available functions
depend on the screen you are working with.
Selection keys
With the Selection keys (arrow up/down) you can select settings in various list
boxes. You can also change values in certain parameter entry fields or enter
alphanumeric characters.
Direction keys
With the Direction keys (arrow left/right) you can move back and forth between the
entry fields.
Numeric/Alphanumeric keys
These keys allow you to enter numeric values in parameter entry fields. In certain
fields where alphabetical characters may be entered you can use the Numeric/
Alphanumeric keys to do so. Pressing them several times in sequence changes the
current value according to Figure 4.
To Next Page
Loading...
Need help?
General
